Presonus StudioLive 24.4.2 Manuel d'utilisateur Page 75

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 150
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 74
4 StudioLive Remote for iPad
4.6 Settings Page
StudioLive
Software Library
Reference Manual
71
4.6 Settings Page
The Settings page allows you to set scrolling and metering
functions and to create custom names for each channel, aux,
and su/jointfilesconvert/1486887/bgroup (16.4.2 and 24.4.2 only) in your mix.
Scroll by Page. Scrolls Through Channels by Page.
When the Scroll by Page option is enabled, the mixer
will scroll to through channels by entire pages, rather
than by individual channels. Turning this option off
will allow you to scroll over by a single channel and offer more granular control.
Scroll by Page can be enabled/disabled for both the Mixer and Aux pages.
Peak Hold Metering. Displays the
Most Recent Signal Peak.
When Peak Hold Metering is enabled, each meter
in SL Remote will continue to display the most recent signal peak. This allows
you to keep an eye on the average loudness of each channel’s signal.
Talkback Bus Assignments. Engages/
Disengages Talkback Assignments.
Use these switches to remotely engage/disengage the
Talkback bus assignments on your StudioLive mixer.
Link Channel Faders. Links Channel Faders
when Channels are Stereo Linked.
When Link Channel Faders is enabled,
stereo-linked channels will no longer have
individual control over each fader in SL
Remote or VSL. This allows you to control the
volume of a stereo channel pair by moving either channel’s fader.
Default to Fader Locate. Activates Fader Locate
on StudioLive when Fader is Moved Remotely.
With the Default to Fader Locate preference enabled, Fader Locate will automatically
engage when a fader is moved remotely in VSL or StudioLive Remote. This preference
allows you to quickly sync your StudioLive when you return to the board.
Power User Tip: If you are remotely controlling the faders on your StudioLive, it is highly
recommended that you enable this preference. When Fader Locate Mode is activated,
the faders on your StudioLive will not be active. By allowing this mode to engage
automatically, you can avoid accidental volume jumps should you forget that a fader
was adjusted up or down in VSL or SL Remote when you go back to your StudioLive.
Vue de la page 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 149 150

Commentaires sur ces manuels

Pas de commentaire